SeaSTAR 3510LR Manual de usuario descargar pdf (Pagina 12)

SeaSTAR 3510LR USER MANUAL

Issue 1.0 11/04

2. Install the DGPS antenna where it has a clear view of the sky in the direction

of the satellite, refer to the NCC in your region for an azimuth/elevation chart

for the satellite service you have subscribed to.

3. Connect the DGPS antenna cable between the DGPS antenna and the

3510LR (Antenna connector on rear panel).

4. Connect the power cable to a suitable 10-32V DC power supply being sure to

check correct polarity. This will power on the unit.

5. If you have an external GPS, you can run a cable from the “GPS” connector

(if installed) to your GPS receiver instead of having two antennas.

6. It is now time to make the 3510LR Receiver acquire the DGPS signal. This

can be done in one of 3 ways:

a). By selecting the service directly in the Set Channel menu (see Set

Channel menu explanation).

b). By entering the frequency and symbol rate directly in the Set Channel

Menu (see Set Channel menu explanation).

c). Using Toolkit as explained in Appendix C.

For options a & b the receiver will indicate that it is starting and frequency

searching by display Init on the main display screen and finally Lock when it has

locked to the signal, in addition a signal strength will be indicated by a bar graph

display. Should the lock indicator not be displayed after 30 – 50 seconds, check

through steps 1 to 6 above.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

Sin comentarios

SeaSTAR 3510LR Manual de usuario Pagina 12